Community
Recent activity
-
Hello there, I have designed a custom board with IMX RT 1010 MCU. The design va...
2D -
This error confirms that Trace32 can't access the target through the JTAG port. ...
-
Thank you for reaching out.It appears that the basic JTAG communication on your ...
-
Hello, Please refer to this script "sdc_secure_device.cmm" under "~~\demo\powe...
Debugging (37)
View all Debugging QuestionsRecent activity
-
Hello Freddy,For debugging over rests and power cycles, you need to use SYStem...
-
I have a Broadcom eval board (BCM95170 rev A0). I have created a SPI CMM program...
27D -
I would to know if there are any lauterbach demo scripts available to debug only...
2M -
1）请您将s32k_arm_debug.bat以及arm_amp_debug.cmm发给我方看一下 2�...
Trace Analysis (7)
View all Trace Analysis QuestionsRecent activity
-
Hello, 1. you just need to enable CONFIG_PID_IN_CONTEXTIDR in the kernel config...
-
Hi, i want to know how can i Measure tasks performance (how much time each task...
9M -
Hello, This post has been processed as a support ticket through email.
-
Hello Andreas, The provided CTL program doesn't compile. It throws an error "ac...
Recent activity
-
You need to use cmm instead of cmd dbg.cmm("DO ~~/demo/tricore/flash/tc39x.cmm ...
-
Hello Mohamed Amin, the answer depends on the used target processor architectur...
-
This was probably asked before, but I couldn't find it. I'd like to program my ...
9M -
Hello,You can remove (or comment) the DIALOG.YESNO subroutine and directly incor...
